35-60J106-021

You are here: › 35-60J106-021

35-60J106-021

The Fenwal 35-J Series Direct Spark Ignition provides all the features, performance, and reliability of our 35-60 Series 24 VAC Direct Spark Ignition control in a Johnson Controls format. Designed to directly replace the Johnson G76x Series, the Fenwal 35-J matches the footprint, mounting hole pattern, and wiring connections of the discontinued Johnson series.

785-002

The Robertshaw® 785 Series Automatic Pilot Relight Kits are designed for use on rooftop heating equipment, water heaters, boilers, space heaters, unit heaters, dryers, and other commercial, industrial, and residential appliances where the problem of pilot outage may occur. It should only be applied to those systems which already incorporate the necessary pilot-safety control system.
Robertshaw part number 10-760

10-760

The Robertshaw® Flame Sensor Assembly and Replacement Sensors have high temperature Kanthol sensor rods that will withstand 1800 °F (982 °C). The sensor rod is 4" long and can be cut and bent to match an original unit. Excellent replacement for most manufacturers' flame sensors.

790-400

The RAM intermittent ignition controls are 24 and 120 VAC. When the thermostat calls for heat, RAM's IID Control simultaneously initiates ignition sparking and opens the pilot valve portion of the gas valve. Pilot flame recognition stops ignition sparking and opens the main valve portion of the gas valve. Pilot burner flame is continuously monitored at a synchronous frequency for the duration of the heating cycle. Should the pilot flame fail during the heating cycle, the control will shut off the main valve until the pilot flame is established. Specifications Electrical Rating (input): 24V 50/60 Hz, 120V 50/60 Hz, 50 mA.Flame Sensor Current: 0.7 mA.Gas Valve Relay Ratings: 5.0 Amps. Temperature Range: -40 °F to 175 °F.Approvals: AGA, CGA.
Robertshaw part number 10-038

10-038

The 1922-001 adaptor allows the high limit switch to be connected into the thermocouple circuit on valves without the slotted magnet.

780-783

The Robertshaw® 780 Series Hot Surface Controls are designed for use on gas fired systems. The system acts on a demand for heat by a switch or thermostat to supply power to the ignition control. On non pre-purge models, the ignitor will be energized immediately and remain on for either of two optional selected ignitor heat-up times: approximately 17 or 34 seconds. For models with the prepurge option, there is a time delay equal to the heat-up time selected before the ignitor is energized. At the end of the ignitor heat-up time, the gas valve is opened supplying gas to the main burner. After several seconds, the ignitor is turned off and the sensor is energized. As long as flame is sensed, the system continues to operate.
Robertshaw part number 41-311

41-311

The Robertshaw® Dryer Ignitor Kit
Robertshaw part number 10-224

10-224

The Robertshaw® Flame Sensor Assembly and Replacement Sensors have high temperature Kanthol sensor rods that will withstand 1800 °F (982 °C). The sensor rod is 4 long and can be cut and bent to match an original unit. Excellent replacement for most manufacturers' flame sensors.
Robertshaw part number 10-227

10-227

The Robertshaw® Flame Sensor Assembly and Replacement Sensors have high temperature Kanthol sensor rods that will withstand 1800 °F (982 °C). The sensor rod is 4 long and can be cut and bent to match an original unit. Excellent replacement for most manufacturers' flame sensors.
Scroll to top